当前位置:首页 >> 其它课程 >> KT板航模遥控飞机F16制作图纸

KT板航模遥控飞机F16制作图纸


CM
0 1 2 3 4 5 6 7 8 9 10

INCH
Sides (Make 2)

0

1

2

3

4

Doublers

F-16C FALCON - EASYBUILD - V

1.02
Designed by Nick Cara Depron = 6mm Wing span = 71cm (28”) Length = 104cm (41”) SETUP :Weight (painted) = 356g Weight (painted and with battery) = 486g Static thrust = 650g Prop = 6x4 Motor = 2000kv ESC = 25A minimum Battery = 1350mAh 3s1p 25C Li-Po (Can take up to 2170mAh) Radio = 3CH (or 4CH with optional rudder) Aileron throw = +/- 20 degrees Elevon throw = +/- 25 degrees Expo = 45% NOTES:Bevel or curve all leading edges. Trim and sand intake to a curve. Use Hot Glue for all parts except carbon rod. Protect lower edge of intake and lower ns with packing tape. Connect both Ailerons and Elevons to a single pair of servos. Paint use colours that will stand out in the sky, don’t leave it white.
Battery position COG 7cm to 8cm from wing break. Cut here for rudder (Optional) Max prop size 6” Cut here for rudder (Optional)

3mm or 4mm Carbon rod epoxy into V slot Missile (attach to wing tip)

Right Aileron

Missile (attach to wing tip) Right Elevon Control point

Control point

Control point

Control point Doublers (For Intake) Doublers (For Intake) Left Elevon

Left Aileron Doublers (For Intake)

MOTOR MOUNT PARTS

Doublers (For Intake) 3mm PLYWOOD

Glue Plywood onto Depron

Doublers

Hatch to acces electronics and battery

Control points (Make 4 from old plastic credit card)

Intake leading edge (Depron or Balsa) Doublers Doublers used in corners

Tail

Cut here for rudder (Optional)

Upper Fuse

Rudder (Optional)

Lower Front Fuse Rudder Servo (Optional)

Control point

Lower Rear Fuse


更多相关文档:
更多相关标签:
网站地图

文档资料共享网 nexoncn.com copyright ©right 2010-2020。
文档资料共享网内容来自网络,如有侵犯请联系客服。email:zhit325@126.com